[jp-pino]

For the battery station (BluEye-Robotics/P2-functional-tests): each slot is a fixture, and its test's name should be the procedure it runs ("Full cycle" or "Short cycle"), since Testlog takes a run's procedure from the record's test_name. Until now the GUI used the test name to tell panels apart, so the battery station had to name its tests "Slot 1"…"Slot 4", and Testlog showed the slot as the procedure.

Change

A test started with htf.Test(..., fixture="Slot 3"), which puts the value in the record's metadata:

• is titled "Slot 3 · Short cycle";
• is ordered by its fixture, then start time;
• replaces the finished panel of the same fixture, whatever procedure either one ran, so slot 2 keeps its result until slot 2 starts again.

A test without a fixture is titled, ordered and replaced by its name, exactly as before. TestState.fixture comes from test_record.metadata.fixture, and is null when absent.

Tests

station.service.spec.ts gains two cases:

• with fixtures, tests are ordered by fixture rather than name, and a finished "Slot 2 · Full cycle" stays while slot 1 runs, then goes when "Slot 2 · Short cycle" starts;
• without a fixture, a test is replaced by name as before, and fixture is null.

ng test: 43 of 43 pass. dist/ is rebuilt with Node 24.

🤖 Generated with Claude Code

[coveralls]

Coverage Report for CI Build 38943015469

Coverage remained the same at 66.335%

Details

• Coverage remained the same as the base build.
• Patch coverage: No coverable lines changed in this PR.
• No coverage regressions found.

Uncovered Changes

No uncovered changes found.

Coverage Regressions

No coverage regressions found.

---

Coverage Stats

Relevant Lines:	7738
Covered Lines:	5133
Line Coverage:	66.33%
Coverage Strength:	3.32 hits per line

---

💛 - Coveralls

[jp-pino]

Not needed: the battery station keeps the slot as the test name (BluEye-Robotics/P2-functional-tests#255).